![]() ![]() Try quitting any programs that may be using it.” Nothing else is using COM3. When I click Turn On this time it says “Connection error: Serial port 'COM3' already in use. It seems like ReplicatorG is still not connected to the Ultimaker as all the buttons are grayed out except “GCode” and “Turn On”. I tried this again with other cards and firmware version but get the same issue. There doesn’t appear to be anything relevant in the console. Check the console for details.” This message comes up really fast as if it didn’t even try. Then finally I click the Upload button and it immediately says “Upload Failed: The firmware update did not succeed. Of the four choices, I picked “Marlin 1.0.0 release candidate 1”. Then on the next page I need to choose the firmware version to install. I go to the menu Machine > Firmware Upgrade and choose “Ultimaker - Arduino Mega Shield v1.5.X (Mega 2560 only)”. Then another message says “Old firmware detected! Firmware version 0.1 detected firmware version 1.0 required.” It says “a newer version (1.0) of the Ultimater - Arduino Mega Shield v1.5.X (Mega 2560 only) firmware is now available.Please select the right driver when changing from 5D to Marlin”. ![]() When I open up RepG I get a “New Firmware Available” message box. However, ReplicatorG has problems connecting to my Ultimaker and I cannot update the firmware through it. The button to update the firmware is grayed out, but other than that, Netfabb seems to be working with my Ultimaker. The nozzle moves with the arrow keys and the platform works with the page up/down keys. ![]() Using Netfabb, I can connect to my Ultimaker using COM3 and use the USB controls. I have recently assembled my new Ultimaker, but cannot figure out how to update the firmware. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |